0	SID Receiver overview

0

Synoptic

0	Printed Circuit Board

0

Tuning

1

Assembly

Last step is to put the PCB in a metallic box with the transformer, fuse and power switch.
See the pictures here below for assembly example:

1	Data Transfer Protocol

Here are some details regarding the data transfer protocol between the MAX187 and the RS-232 interface.

The MAX187 signals are connected to the following RS-232 pins:

• /CS ↔ RTS
• SCLK ↔ DTR
• DSR ↔ DOUT

The RS-232 standard defines the positive voltage levels for logic one and negative voltage level for logic zero.

Protocol is detailed in the following documents:

•  MAX187 Datasheet
•  Maxim application note 827. This note contains a C code example.

The overall sequence is described below:

• Unset RTS (RTS=-5V; /CS='1') to deselect MAX187
• Set DTR (DTR=+5V; SCLK='0')
• Set RTS (RTS=+5V; /CS='0') to select MAX187. This starts the conversion.
• Wait till the conversion is done (DOUT must be '1'; DSR=-5V)
• Clock in 12 bits. MSB are first:
  • Unset DTR (DTR=-5V; SCLK='1')
  • Set DTR (DTR=+5V; SCLK='0')
  • Read a bit (signal DOUT, DSR)
• Add a 13^th falling edge:
  • Unset DTR (DTR=-5V; SCLK='1')
  • Set DTR (DTR=+5V; SCLK='0')
• Unset RTS (RTS=-5V; /CS='1') to deselect MAX187
• Unset DTR (DTR=-5V; SCLK='1')